DEP uitlaatdemper Honda CR 250R 1986

Product Information

Our 2 stroke silencers are designed to fit OE and DEP front pipes. The

silencers are manufactured with a polished aluminium outer canister and a

mild steel internal perforated core, surrounded with a high temperature

Eglass packing. All silencers have been designed as a performance

enhancing product for optimum power increase, we advise this to be used

with a DEP front pipe. Our silencers are easily repackable.

WARNING

During use exhaust systems get hot. To avoid danger of burning, do not

remove or touch until adequate cooling time has been allowed.

2 Stroke Silencer Fitting Instructions

Loosen the silencer mounting bolts from the frame and remove your

original silencer from the bike. Install the DEP silencer, making sure it does

not touch the sub-frame before tightening mounting bolts. Retain any

rubber grommets/sleeves from the original silencer and refit on your DEP

silencer, if required. All the exhaust fixing points should be slackened and

then fully tightened allowing all frame mounting points to line up exactly. A

silencer fitted under stress can cause failure or damage to the product.

DEP cannot be held responsible for any incorrectly fitted products. The

fitting to non-original equipment or DEP equipment is the responsibility of

the end user.

2 Stroke Silencer Re-packing Instructions

The performance and low noise efficiency of this silencer will be impaired if

it is not serviced on a regular basis. Remove the bolts or rivets, remove the

end caps, inner core and packing material. Inspect and clean where

necessary. Re-pack the silencer with DEP matt packing. To maintain peak

performance the silencer should be inspected regularly and the packing

material replaced if it has exceeded its serviceable life.